Question: What is the standard size of faucet supply line?

The main pipes, which come off the main water supply, typically measure 3/4 inches in diameter. The branch lines, which feed individual fixtures, typically measure 1/2 inch in diameter.

What size are Moen supply lines?

Moen faucets typically utilize either flexible supplies with ⅜ compression fittings or ½ IPS connections.

Are three hole faucets standard size?

1 3/8 inches While not all faucets are the same, the standard sink faucet hole size is 1 3/8 inches. For some, a 1 1/2-inch hole may be required. If the faucet is a three or four-hole faucet, youll need holes 6 or 8 inches across your kitchen sink. Widespread faucet hole spaces can be as wide as 16 inches.

Are all single hole faucets standard size?

Since there are many different types of kitchen faucets, there is no standard or typical hole size. The faucet hole size will vary depending on the kitchen faucet you plan to install. Measure the faucet hole size before you shop.

What does 3 hole faucet mean?

Three holes are used for the spout and two handles. A fourth hole is typically used for an accessory, such as a soap dispenser or side sprays. If youre installing a single-handle faucet into a sink with three holes, the deck plate will usually cover up the unused openings.

Are bathroom faucets standard size?

Standard centerset faucet units, typically used on bathroom sinks, measure 4 inches on center. Wideset faucets and spouts may be units with bases, but may also mount only handles and spouts on walls or tubs. Standard widespread faucets measure between 8 and 16 inches on center.

How do you tell if a faucet will fit?

Measure. If you have three holes in the sink or counter, you will need to measure the distance from the center of the hole on the left to the center of the hole on the right. If this measurement is 6 inches or larger, you can install a widespread or 8-inch spread faucet.

Can a handyman replace a faucet?

Most faucet replacements can be done by a handyman and dont require the journeyman plumber. However, because youre dealing with water, you should always double check for leaks within the first 24-48 hours. Of course this would include removing the old faucet.

How do I measure for a new bathroom faucet?

Make sure to measure your faucet centers. This refers to the distance, in inches, between the pre-drilled faucet holes in the sink or vanity, from the very center of the left hole to the very center of the right hole. These center points should correspond to the center connections of the faucets to be installed there.

Are all bathroom faucets standard size?

Bathroom sink faucets are not the same size and are not designed to fit all sinks universally. That said, excluding specialty built custom work, bathroom faucets are regularly manufactured in one of four different spacing configurations to accommodate the most common and popular faucet types: Single-Hole.

Reach out

Find us at the office

Dayberry- Antinucci street no. 75, 92993 Belfast, United Kingdom Northern Ireland

Give us a ring

Daan Hilger
+47 129 536 826
Mon - Fri, 9:00-17:00

Tell us about you